Dishwasher Drain Hose Installation Instructions

Install the drain hose important.

Dishwasher drain hose installation instructions.

Make the high loop then attach the end of the hose to the y branch tailpiece using a hose clamp. Position water line and house wiring on the floor to avoid interference with base of dishwasher. Use a drill and a 1 3 8 inch spade bit or hole saw to make a hole in the cabinet. Connect drain hose to waste te e or waste disposer using one of the following methods.

Figure 24 figure 25 note. Slide dishwasher into the opening a few inches at a time. It is recommended that the drain. High loop to garbage disposal follow the same instructions as 1 except connect the dishwasher drain hose directly into the garbage disposal.

If an air gap fitting is used there will be two lengths of drain hose. Drain hose maximum drain hose length 10 installation instructions step 7slide dishwasher partially into cabinet do not push against front panel with knees. Drain hose connection plumbing preparation section of this manual. The factory drain hose on the dishwasher which runs from the dishwasher to the smaller of the two tailpieces on the air gap and a 7 8 inch inside diameter hose that runs from the other tailpiece on the air gap to the dishwasher nipple on the garbage disposal.

Drain connection with air gap and garbage disposal. Always use a new drain hose when installing a new replacement dishwasher. High loop to drain pull as much of the drain hose into the sink cabinet as possible. Connect drain hose to house plumbing 20 50 8 cm minimum above the floor.

Prepare the sink tailpiece or garbage disposal inlet. You may need. How to install a dishwasher drain step 1. Drill holes for the drain hose.

Drill a 1 3 8 cm diameter hole in cabinet wall or floor on the side of the opening closest to the sink. The drain hose should. If the dishwasher drain hose is to be connected to a disposer dishwasher drain connection remove the plug from the disposer s dishwasher drain connection. Install a branch tailpiece by disassembling the p trap.